Compressor Installation - continued - TB-9-2320-364-13-P-10482

TB 9-2320-364-13&P-1

11. Install screw (20) in flywheel housing (19)

with washer (16) and nut (15). Tighten

nut (15) to 25-30 lb-ft (34-41 Nm).

12. Install fitting (21) on fuel return line (13).

13. Install fuel hose extension (22) on

fitting (21).

14. Cap open end of fuel hose extension (22).

NOTE

Use cable ties as required to secure wire

harnesses forward of flywheel housing,

so that wire harnesses do not come in

contact with two compressor drive belts

that will be installed in later steps.

15. Secure wire harness (23) with cable ties as

required.

16. Remove four screws (24) and lockwashers (25)

from cam drive cover (26).

17. Remove screw (27) and washer (28) from cam

drive cover (26).

18. Remove cam drive cover (26) and gasket (29)

from flywheel housing (19).

19. Remove two screws (30) and lockwashers (31)

from transmission (32). Discard lockwashers.

0055-12