Heater/Evaporator Installation. - continued

TB 9-2320-364-13&P-1

CAUTION

Wire 1082 and wire 1052 being cut in

Steps (50) and (51) are from the cab

wiring harness. Do not cut wire 1082

coming from the circuit breaker installed

in Step (47). Failure to comply may result

in damage to equipment.

50. Cut wire 1082 (79) below terminal (80). Discard

terminal (80).

51. Cut wire 1052 (81) below lamp socket (82). Discard

lamp socket (82).

52. Install heat shrink (83) on end of cut

wire 1082 (79).

53. Install end of lighting wire harness (84)

on end of cut wire 1052 (81) with butt

splice (85).

54. Install ring terminal (86) of lighting wire

harness (84) on heater/evaporator (4)

with screw (87), lockwasher (88) and

washer (89).

55. Install bulb (90) in lighting wire

harness (84).

56. Install lighting wire harness (84) and

bulb (90) in light source (91).

57. Install clip (92) on panel (93).

58. Install light source (91) on clip (92).

0055-46