INSTALL - TM-10-4110-262-13-P0100

TM 10-4110-262-13&P

0015 00

INSTALL

To install the shelf system in the ADR-300, follow these steps:

1. If side supports are not pre-assembled, assemble, four right-side support sets, each consisting of one

long left-hand side support joined to one short right-hand side support. Leave nuts loose to allow

adjustment in the width of the assembly.

Rubber Spacer

Shelf Weldment

Side Support, LH

(Short)

Side Support

Shelf Support

Assembly Bolt

Bolt

Side Support RH

(Long)

2. Assemble four left-side support sets, consisting of one long right-hand side support joined to one

short left-hand side support. Leave nuts loose to allow adjustment in the width of the assembly.

3. Confirm that four rubber spacers are installed in each short side support.

4. Position one shelf weldment on the container floor and align the bolt holes in the weldment with the

three threaded inserts in the container floor. Thread three bolts through the weldment into each of

the inserts. Do not tighten the bolts.

5. Facing the shelves, position two right-side support sets at the right end of the weldment. Insert the

shelf support bolts through the supports and the weldment. Thread the nuts onto the shelf support

bolts. Do not tighten the nuts.

6. Facing the shelves, position two left-side support sets at the left end of the weldment. Insert the shelf

support bolts through the supports and the weldment. Thread the nuts onto the shelf support bolts.

Do not tighten the nuts.

7. Repeat Steps 4-6 on the opposite side of the container aisle.

8. Confirm that five rubber spacers are installed on each of the two top supports. Place one top support

on top of the four long side supports at the RU-end of the container with the vertical surface of the top

support toward the shelf.

9. Match the holes in the side supports and the top support and install bolts, washers and nuts in each

hole. Do not tighten bolts.

10. Repeat Step 8 and 9 for the door-end of the shelf system.

0015 00-2