Solenoid Valve Body

TM 10-4110-262-13&P

0040 00

Solenoid Valve Body

NOTE

Valves that have nylon seats must be disassembled before soldering.

1. Recover the refrigerant from the system.

2. Remove the four screws securing the valve plunger to the valve body.

3. Remove the plunger assembly and valve diaphragm. Note which face of the diaphragm is oriented

toward the plunger.

4. Remove the mounting bolt under the valve body attached to the bracket.

CAUTION

Protect the wires from the torch during de-soldering and re-soldering.

Failure to comply may result in damage to equipment.

5. Remove the wires from the protruding stud on the back of the control panel.

6. If damaged, unsolder the hot gas lines from the valve body and remove the valve from the unit.

INSTALL

Solenoid Valve Body

CAUTION

Do not contaminate the system when preparing refrigeration tubing for

soldering. Contamination may cause restrictions in the refrigeration

system. Failure to comply may result in damage to the equipment.

1. Clean the refrigeration tubes for soldering.

2. Remove the coil, plunger and diaphragm from the replacement valve. Place the valve body in

position.

3. Remove the four screws from the compressor terminal box and move the box to make room for

re-soldering the valve body.

4. Install the mounting bolt to the bracket.

0040 00-3