REMOVE - TM-10-4110-262-13-P0228

TM 10-4110-262-13&P

0043 00

CAUTION

The evaporator coil fins are fragile and easily bent or otherwise

deformed. Deformed fins reduce the performance of the refrigeration

system. Place a folded piece of cardboard or other device over the fins to

protect the fins while working near the coil.

CAUTION

Take care to avoid bending, kinking or otherwise damaging the hot gas

heating coil. Failure to comply may result in damage to equipment.

2. Remove the four screws from each side of the drain pan and one screw from the middle of the

evaporator opening. Lower the drain pan.

3. Remove the two lower evaporator grille bolts (8 millimeters).

4. Remove the four bolts from the rear of the drain pan.

CAUTION

Drain pan heater is attached to the pan. Not removing the clamp may

damage the refrigerant line. Failure to comply may result in damage to

equipment.

5. Gently lower the pan to access the hot gas drain pan heater clamp on the right side.

6. Remove the 8-millimeter bolt from the clamp.

7. Remove the drain pan.

DTS

1. Remove the two screws holding the DTS on the side of the evaporator coil.

2. Cut the wire ties.

3. Disconnect the DTS wire from the refrigerator wiring harness at the connector.

4. Remove the DTS.

0043 00-2