Heating Element - TM-10-4110-262-13-P0233

TM 10-4110-262-13&P

0044 00

INSTALL

Heating Element

1. Install the heating elements in the retaining clips on the evaporator coil by gently rotating the clips

away from the coil face.

2. Gently insert the heating element into the opened clip. Take care to avoid bending or damaging the

coil fins.

3. Insert both of the heating coil wires through the protective rubber grommet.

4. Insert the heater wire connectors through the hole on the evaporator coil face.

5. Install the protective rubber grommet in the hole in the evaporation coil face.

6. Reconnect the heater wire connectors to the evaporator wire harness.

Drain Pan

1. Support the drain pan in position.

NOTE

If necessary, remove shelving panels to install the drain pan.

2. Install the clamp on the hot gas drain pan heater. Do not tighten the bolt.

3. Start threading the four bolts to the bottom of the drain pan. Use the washers with gaskets.

4. Tighten the bolt on the clamp used on the hot gas drain pan heater.

5. Tighten the four bolts that you threaded in Step 9.

6. Position the drain pan and align the bolt holes.

7. Install all the bolts, but do not tighten at this time.

8. Tighten the bolts after installing all the bolts.

9. Use wire tires to secure wires.

0044 00-3