|
| |
HOW IT
WORKS
• Compressor runs
• Condenser fan runs
• Water pump runs (circulates water)
• Cutter grid is warm to touch
WHEN THE DESIRED ICE SLAB THICKNESS IS
REACHED, THE HARVEST CYCLE BEGINS AND
THE FOLLOWING HAPPENS:
• Evaporator thermostat is satisfied
• Compressor keeps running
• Condenser fan stops or turns very slowly
• Water pump stops
• Hot gas solenoid opens
• Water inlet valve opens
• Excess water is flushed out of the drain pan
• Cutter grid is warm to the touch
NOTE: Normal harvest cycle takes 60 to 120
seconds.
MACHINE RESUMES FREEZING AFTER SLAB IS
RELEASED
FROM
EVAPORATOR
AND
THE
CUTTING PROCESS BEGINS.
WHEN
THE
STORAGE
BIN
IS
FILLED,
BIN
THERMOSTAT OPENS.
• Cutter grid remains on
THINGS TO
REMEMBER
• Water enters only during the defrost cycle. Therefore
the first cycle will be completed without water in the
system.
• As the room and water temperatures vary, so will the
amount of ice produced. This means that higher
operating temperatures will result in reduced ice
production.
• The unit will shut off when ice in the storage bin
touches the bin thermostat well and will automatically
cycle to keep the bin full.
• The storage bin is not refrigerated and some meltage
will occur. This, too, varies with the room
temperature.
• The unit needs good air circulation to perform
efficiently. Keep the front grill and the condenser
clean.
• The water system, including filter screen in the water
inlet solenoid valve, needs to be cleaned periodically
for good circulation. Instructions are located on the
inner door panel.
OPERATING
INSTRUCTIONS
• For complete operating information, refer to the Use
and Care Guide.
• Before starting, wash out interior of cabinet with a
Baking Soda solution (2 tablespoons soda to a quart
of warm water). Rinse thoroughly.
• Make certain the water is turned on.
• Turn switch to the "ON" position.
IMPORTANT:
Allow unit to run for 3 hours before expecting ice
and for 24 hours before trying to set the thickness
control.
If installed above 2,000 feet altitude, see page 2 for
thermostat adjustments.
6
|
