UNIT HOUSING ITEMS (cont)

TM5-4110-234-14

TO 40R7-5-7-1

If it was necessary to remove the refrigerator from the box wall (c and d above):

(1)

Remove the four mounting angles and the attaching hardware.

(2)

Move the unit into position.

(3)

Check the area of the wall where the gaskets will seal. This must be a smooth, clean, flat surface.

(4)

Carefully guide the evaporator section through the wall opening.

(5) When the unit is approximately in place check gasket seal area for uniform clearance between the sides

of the wall opening and slide the unit straight back until the gasket makes uniform contact with the wall.

(6)

If gasket contact is not uniform top to bottom, shim the unit until a uniform seal contact is obtained. a

(7) From the inside of the box, place the four mounting angles on the bolts extending through the four

corners of the opening. See figure 4-1.

(8)

Holding the angles in place install the washers and nuts finger tight to all four corners.

(9)

Uniformly tighten all four points taking a few turns on each in rotation to insure an even seal.

(10) When the gasket is compressed evenly to approximately 1/2 to 2/3 of its original thickness a good seal

has been achieved.

4-98