|
| |
Section II. ELECTRICAL COMPONENTS
6-8. Fan Motors
a. General. The condenser fan motor and the
evaporator fan motor are identical. Motors for air
conditioners having different electrical charac-
teristics are similar in construction and the repair
instructions contained in this paragraph apply to all
motors except as noted.
b. Disassembly. Refer to figure 6-4 and
disassemble motor as follows:
(1) Remove four hex nuts (1) four through
bolts (2) and eight flat washers (3). Remove rear
end bell (4).
(2) Pull out rotor (9) and remove shims (5 and
6), bearing spacers (7) and bearings (8).
(3) Remove screw (10), washer (11), and loop
clamp (12). Remove screw (13), washer (14), and
ground terminal ( 15). Disconnect leads and remove
cable (16) and strain relief bushing (17).
(4) For single phase motors, remove front end
bell (27) from stator (29).
(5) For three phase motors, refer to paragraph
4-39 and remove thermal protector housings (21
and 25) thermal protectors (22 and 26) and at-
taching hardware. Remove front end bell (28) from
stator (29).
KEY to fig. 6-4:
6-8
|
