|
| |
Caution: For safe operation, connect a No.
d. Air Ducts. Connect air ducts contingent to site
10 AWG (min.) ground wire to ground con-
of installation. Mount air filter in duct work if an
nection.
c. Connections. Connect the main
Section II.
2-5. Dismantling for Movement
a. Disconnect main power cable.
evaporator return air duct is required.
power cable.
Note. Operation without filtration will clog coils.
MOVEMENT TO A NEW WORKSITE
e. If the air conditioner is to be moved over a long
distance, recrate it by reversing the unpacking
b. Disconnect drain lines from the outlets.
procedures. See paragraph 2-2.
c. Disconnect any air ducts and install the
2-6. Reinstallation After Movement
evaporator air discharge grille and air return grille.
After movement,
d. Remove the unit from the mounting surface.
follow the procedures in
paragraph 2-4 to reinstall the air conditioner.
Section III. CONTROLS AND INSTRUMENTS
2-7. General
2-8. Controls and Instruments
This section describes, locates, and illustrates the
The location and the function of the controls and
various controls and provides the operator crew
instruments are illustrated in figure 2-3.
sufficient information to insure proper operation of
the air conditioner.
2-3
|
