|
| |
Figure 4-11. Evaporator fan and motor assembly.
(1) Refer to paragraph 4-18 and remove
evaporator air inlet louver.
(2) Disconnect motor electrical connector.
(3) Refer to paragraph 4-25 and disconnect
evaporator drain tubing.
(4) Remove three brackets above fan to
facilitate removal of fan and motor assembly.
Remove two screws, lock washers and clamps.
Move temperature selector bulb clear of fan.
(5) Remove four screws and lock washers
securing fan and motor base to resilient mounts and
remove fan and motor assembly.
(6) To remove motor from the assembly,
remove four cap screws and lock washers from
underside of base. Loosen setscrew in fan and
motor shaft and remove motor.
b. Condenser Fan Motor. Remove condenser fan
motor as follows:
(1) Refer to paragraph 4-21 and remove
housing covers.
(2) Refer to figure 4-12 and remove four
screws and flat washers that secure motor mounting
plate to housing.
4-21
|
