Section I.

TM 5-4120-270-35P

Section I.

INTRODUCTION

Code

Explanation

1. Scope

purposes because the combat or military

This manual lists repair parts, special tools, test

essentiality of the end item dictated that a

and support equipment required for the performance of

minimum quantity be available in the supply

direct support, general support, and depot maintenance

system.

of the air conditioner.

Repair Parts, Special Tools and Test Equipment

2. General

which are not procured or stocked, as such, in

This Repair Parts and Special Tools List is divided

the supply system but are to be manufactured at

into the following sections:

indicated maintenance levels.

Repair Parts-Section II. A list of repair parts

Assemblies which are not procured or stocked as

authorized for the performance of maintenance at the

such, but are made up of two or more units.

direct support, general support, and depot level in figure

Such component units carry individual stock

and item number sequence.

numbers and descriptions, are procured and

Special Tools, Test and Support Equipment-

stocked separately and can be assembled to

Section III. (Not Applicable).

form the required assembly at indicated

Federal Stock Number and Reference

maintenance categories.

Number Index-Section IV. A list of Federal stock

Parts and assemblies that are not procured or

numbers in ascending numerical sequence followed by

stocked because the failure rate is normally

a list of reference numbers in ascending alphanumeric

below that of the applicable end item or

sequence, cross-referenced to the illustration figure

component. The failure of such part or assembly

number and item number.

should result in retirement of the end item from

the supply system.

NOTE

Repair parts which are not procured or stocked.

Items not illustrated are

cross-

The requirement for such items will be filled by

referenced to group number.

the next higher assembly or component.

Repair Parts, Special Tools and Test Equipment

3. Explanation of Columns

which are not stocked and have no for seen

The following provides an explanation of columns in the

mortality. The indicated maintenance category

tabular lists in sections II and III.

requiring such repair parts will attempt to obtain

the parts through cannibalization or salvage, the

Source, Maintenance, and Recoverability

item may be requisitioned with exception data,

Codes (SMR).

from the end item manager, for immediate use.

(1) Source code indicates the selection status

Major assemblies that are procured with PEMA

and source for the listed item. Source codes used are:

funds for initial issue only as exchange

assemblies at DSU and GSU level. These

Code

Explanation

assemblies will not be stocked above the DS

Repair Parts, Special Tools and Test Equipment

and GS level or returned to depot supply level.

supplied from GSA/DSA, or Army supply sys-

(2) Maintenance code indicates the

tem, and authorized for use at indicated main-

lowest category of maintenance authorized to install the

tenance categories.

listed item. The maintenance level codes are:

Repair Parts, Special Tools and Test Equipment

Code

Explanation

which are procured and stocked for insurance

O.................................. Organizational maintenance

F .................................. Direct support maintenance

H .................................. General support maintenance

D .................................. Depot maintenance

(3) Recoverability code indicates whether

unserviceable items should be returned for recovery or

salvage.

Items not coded are expendable.

Recoverability codes are:

iii