Remote Control.

TM 5-4120-274-15

THERMOSTAT SENSING BULB:

STEP 1 - REMOVE THERMOSTAT SENSING BULB BY REMOVING

SCREW AND CLAMP.

STEP 2 - REMOVE BACK PANEL BY REMOVING SCREWS (4) AND

LOCKNUTS (4).

STEP 3 - REMOVE THERMOSTAT BY REMOVING SCREWS (4).

Figure 2-1 (2)-Continued.

control operation of the air conditioner. A block-

or receptacle alternate. Alternate eletrical power

off plate provided must be used when thiS con-

connections openings are provided at both- sides

trol box is used as a remote control.

of the unit and front of the unit, any location may

be used by interchanging the power receptacle at

(2) Remote control connection.

rear of unit and one of the cover plates at sides

(a) Disconnect power source from unit.

or front of unit. Be sure to attach cover plate over

(b) Refer to figure 2-1 and set the unit

unused location at rear of unit to prevent air

for remote control operation.

from being drawn through the opening.

e. Remote Control.

2-6. Equipment Conversion

(1) General. The control box (fig. 2-1) may

Not Applicable.

be removed from the unit and used for remote

2-3