|
| |
3 - 12 . Control Panel
(2) Refer to paragraph 3-8 and disconnect
a. Inspection.
bell crank louver control (cable) from switch #1.
(1) Refer to figure 3-6 and inspect control
c. Installation
panel for dents, breaks, cracks and damaged or
(1) Refer to figure 3-6 and replace control
missing hardware.
panel.
(2) Straighten all dents and replace damaged
(2) Refer to paragraph
or defective control panel or hardware as necessary.
control cable to switch # 1.
b. Removal.
(3) Refer to figure 3-6
(1) Refer to figure
3-6 and remove front
panel.
panel.
3-8
and
and connect
replace front
Figure 3-6. Evaporator front panel and control panel. removal and installation.
3-13. Stud Fastcner Receptacles
b. Installation
a. R e m o v a l
(1) Place fastener on frame and while holding
(1) Remove required panel.
it in place. insert the two rivets which will secure it
(2 ) Drill out rivets holding receptacle to the
to the frame.
condenser or evaporator angle frame. Remove
(2) Replace panel and check for tightness.
receptacle.
3-13
|
