Inspection.

TM 5-4120-339-14

(b) Dry inlet screen with compressed air.

(3) Inspection.

(a) Inspect inlet screen for bent, dented or broken parts.

(b) Inspect for missing or defective attaching hardware.

(4) Repair.

(a) Straighten minor bends and dents in inlet screen.

(b) Replace missing or defective attaching hardware.

(5) Replace. Replace fresh air inlet screen if damaged beyond repair.

(6) Installation. (See figure 3-3.)

g. Condenser Fan Guard and Condenser Coil Guard.

(1) Removal. (See figure 3-3.)

(2) Cleaning.

(a) Wash guards with a stream of fresh water.

WARNING

When using compressed air for blowing and cleaning, air hose pressure must not

exceed 30 psig (2ks/cm2), and individuals must wear eye protection equipment.

(b) Dry guards with compressed air.

(3) Inspection.

(a) Inspect guards for bent, dented or broken parts.

(b) Inspect guards for missing or defective attaching hardware.

(4) Repair.

(a) Straighten minor bends and dents in guards and guard screens.

(b) Replace missing or defective attaching hardware.

(5) Replace. Replace either or both guards if damaged beyond repair.

(6) Installation. (See figure 3-3.)

h. Air Filter.

(1) Removal. (See figure 3-3.)

3-13