Figure 5-15. Condenser Coil
(3) Remove the condenser air inlet guard.
(4) Discharge and purge the refrigeration system per paragraphs 5-9 and 5-10.
(5) See paragraph 5-30 and remove the compressor.
(6) Remove the auxiliary power input connector J11 from the upper rear corner and place cable end out
and over the side of the unit.
Disconnect the flare nut nearest the sight glass from the dehydrator.
Remove the sight glass mounting plate.
Remove the clamps from the receiver.
Debraze the tee from the hot gas line at the lower corner of the coil.