 |
|||
|
|
|||
|
Page Title:
Figure 3-9. Removal of control box rear panel and components (sheet 1 of 2) |
|
||
| ||||||||||
|
|
 TM 5-4120-356-14
LOOSEN SETSCREWS IN KNOB (11) AND REMOVE KNOB FROM PANEL.
1.
2. REMOVE FOUR SCREWS (6) AND NUTS (7) AND REMOVE REAR PANEL (8) FROM CONTROL BOX (1).
REMOVE GROMMET (9) AND CAPILLARY TUBE FROM REAR PANEL.
3.
CONTROL BOX REAR PANEL INSTALLATION
POSITION GROMMET (9) AND CAPILLARY TUBE IN MOUNTING NOTCH ON REAR PANEL.
1.
POSITION REAR PANEL ON CONTROL BOX WITH TEMPERATURE CONTROL THERMOSTAT SHAFT EXTENDING
2.
THROUGH MOUNTING HOLE.
3. SECURE REAR PANEL WITH FOUR SCREWS (6) AND NUTS (7).
INSTALL KNOB (11) ON SHAFT OF TEMPERATURE CONTROL THERMOSTAT AND TIGHTEN SETSCREWS.
4.
SELECTOR SWITCH REMOVAL
1.
REMOVE CONTROL BOX REAR PANEL.
2.
3.
LOOSEN SETSCREWS IN KNOB (10) AND REMOVE KNOB FROM PANEL.
REMOVE NUT (14) FROM SHAFT OF SELECTOR SWITCH (16) AND PULL SELECTOR SWITCH FREE FROM PANEL
4.
AND CONTROL BOX.
TS5-4120-356-14/3-9
REMOVE WASHER (15) FROM SHAFT OF SELECTOR SWITCH.
5.
TAG AND DISCONNECT ELECTRICAL LEADS FROM SELECTOR SWITCH.
6.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals