|
| |
TM 5-4120-361-14
(a) With inner nuts in place, in-
the bushing flange adjacent to the actu-
stall the outer cable in the support
ator nut.
Rotate actuator nut to the
bracket.
left (counterclockwise) to place the ac-
(b) Install the grommet in the
intermediate cable support.
(c) Fasten the cable ends in the
support brackets by installing the outer
nuts.
(d) Thread the inner cable
through the outer cable.
Attach the
looped end of the inner cable to the
vent door.
(e) Lubricate the threads on the
actuator, install actuator and actuator
nut in the fixed actuator bracket, then
install the removable bracket.
Ensure
that bushings are in both brackets with
tuator in the uppermost position.
(2) Adjust the damper actuator as
follows:
a.
Ensure that the damper door
is closed.
b.
Insert cable end in actuator,
adjusting, if necessary, the cable nuts
to properly seat the cable end in the
actuator.
c.
Tighten the actuator setscrew
onto the cable.
(3) Refer to figure 4-1 and install
the evaporator inlet louver.
4-35/(4-36 Blank)
|
