 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4120-361-24P
tion of the usable On Codes used in this
(f) Description. Indicates
publication are:
the Federal item name and, if required,
a minimum description to identify the
item. Items that are included in kits
Used On
Code
and sets are listed below the name of
DBJ
60 Hz Model CH636-1
the kit or set with the quantity of
each item in the kit or set indicated
DBK
400 Hz Model CH436-1
in the Quantity Incorporated In Unit
Column. When the part to be used
b. The following publication pertains
to the air conditioner and its compo-
differs between serial numbers of the
nents:
same model, the effective serial num-
bers are shown as the last line of the
description. In the Special Tools List,
Publication and Short Title
the initial basis of issue (BOI) appears
TM 5-4120-361-14, Maintenance Manual
as the last line in the entry for each
special tool, special TMDE, and other
1-5.
HOW TO LOCATE REPAIR PARTS.
special support equipment. When density
of equipment supported exceeds density
a. When National Stock Number or Part
spread indicated in the basis of issue,
Number is Unknown:
the total authorization is increased ac-
cordingly.
(1) First. Using the table of con-
tents, determine the functional group
within which the item belongs. This is
necessary since illustrations are pre-
pared for functional groups and listings
are divided into the same groups.
(2) Second. Find the illustration
covering the functional group to which
(g) Unit of Measure (U/M).
Indicates the standard of basic quantity
the item belongs.
of the listed item as used in performing
the actual maintenance function. This
(3) Third. Identify the item on
measure is expressed by a two-character
the illustration and note the illustra-
tion figure and item number of the item.
alphabetical abbreviation (e.g., ea, in,
pr, etc). When the unit of measure dif-
fers from the unit of issue, the lowest
unit of issue that will satisfy the re-
(4) Fourth. Using the Repair Parts
Listing, find the figure and item number
quired units of measure will be requi-
noted on the illustration.
sitioned.
b. When National Stock Number or Part
(h) Quantity Incorporated in
Number is Known:
Unit. Indicates the quantity of the
item used in the breakout shown on the
illustration figure, which is prepared
(1) First. Using the Index of
National Stock Numbers and Part Numbers,
for a functional group, subfunctional
group, or an assembly. A "V" appearing
find the pertinent National stock number
or part number. This index is in NIIN
in this column in lieu of a quantity in-
sesquence followed by a list of part
dicates that no specific quantity is ap-
numbers in alphanumeric sequence, cross-
plicable (e.g., shims, spacers, etc.).
-referenced to the illustration figure
number and item number.
SPECIAL INFORMATION.
1-4.
(2) Second. After finding the fig-
ure and item number, locate the figure
a. Usable On Codes are shown in the
and item number in the repair parts
description column. Uncoded items are
list.
applicable to all models. Identifica-
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals