Chapter 4. ORGANIZATION MAINTENANCE INSTRUCTIONS

TM 5-4120-369-14

ORGANIZATION MAINTENANCE INSTRUCTIONS

CHAPTER 4.

Section I .

SERVICE UPON RECEIPT OF MATERIAL

4-1.

GENERAL.

Instructions for unloading, unpacking and installing the air conditioner are covered in

Chapter 2, Section III.

4-2.

INSPECTING AND SERVICING EQUIPMENT.

General inspection of the equipment is covered in Chapter 2, Section II. If possible damage

has occurred, requiring removal of covers or other components not authorized for removal by the

operator, further inspection of internal components is to be performed by organizational mainten-

ance personnel. If other than new equipment has been received, a thorough inspection is to be

performed. Make a thorough check to see that all wiring, lines and tubing are secure. Pay

particular attention to the evaporator and condenser coils and main power receptacle connectors.

Be sure that all visible wiring and insulation are not broken or frayed. Also check the evapor-

ator and condenser fan motors.

Section II.

MOVEMENT TO A NEW WORKSITE.

4-3.

PREPARATION FOR MOVEMENT. To prepare the air conditioner for movement, proceed

as follows.

4-4.

DISMANTLING FOR MOVEMENT.

Disconnect main power cable, and grounding strap.

Disconnect drain line from outlet.

Disconnect air ducts and install the evaporator inlet and outlet grilles.

Remove unit from mounting surface.

If air conditioner is to be moved over a long distance, recrate it.

REINSTALLATION AFTER MOVEMENT.

4-5.

After movement, follow procedures in paragraph 2-9 to reinstall

the air conditioner.

Section III.

REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT

4-6.

TOOLS AND EQUIPMENT.

No tools or equipment are issued with the air conditioner.

Appendix C lists the standard

tools required to service the unit.

4-7.

SPECIAL TOOLS AND EQUIPMENT.

No special tools or equipment are required for maintenance of the air conditioner.

4-8.

MAINTENANCE REPAIR PARTS.

Repair parts and equipment are listed and illustrated in the repair parts and special tool list

covering organizational maintenance for this equipment. (See TM 5-4120-369-24P.)

4-1