EVAPORATOR FAN AND MOTOR ASSEMBLY (B-3)

TM 5-4120-369-14

EVAPORATOR FAN AND MOTOR ASSEMBLY (B-3) - Continued

4-32.

Evaporator fan and motor assembly, removal

Figure 4-22.

and installation

Removal.

(1) Refer to paragraph 4-19 and remove the evaporator air inlet louver.

(2) Remove the evaporator fan and motor assembly as follows:

(a) Disconnect connector.

(b) Remove 2 screws and clamps holding thermocouple in place.

(d) Remove 4 mounting screws (allen head).

(e) Remove fan/motor assembly.

(3) Disassemble the fan/motor assembly as follows:

(f) Remove 2 screws and clamps.

(g) Loosen 2 setscrews and pull fan from motor shaft,

(h) Remove 4 screws and remove motor.

(i) Remove 2 screws and washers holding bracket in place.

Remove nut and impeller.

(j)

(k) Remove 4 screws and fan housing.

4-40