|
| |
TM 5-4120-377-14
(5)
(6)
clamps.
(7)
(8)
(9)
box.
(10)
(11)
(12)
(13)
Figure 4-53. Junction Box Removal/Installation
Using screwdriver, loosen four captive panel fastener screws in junction
TS4120-377-14/4-53
box mounting flange.
Slip junction box out to gain access to control panel, P2 and P3 plugs, and push-pull control wire
Using screwdriver, remove four screws from control panel.
Support control panel so that capillary line and electrical harness will not be damaged.
Using screwdriver, remove two screws and spacers from push-pull cable clamps on side of junction
Using screwdriver, loosen screw in core end fitting and remove from end of push-pull control wire.
Pull push-pull control wire free from junction box.
Disconnect P2 and P3 harness plugs.
Remove junction box.
b. Installation
(1)
(2)
(3)
(4)
(5)
Place junction box close enough to unit to attach plugs P2 and P3.
Connect plug P2 to connector J2.
Connect plug P3 to connector J3.
Using screwdriver, secure control panel to junction box with four screws.
Check that circuit breaker reset knob on rear of air conditioner is pushed in all the way.
4-92
|
