|
| |
TM 5-4120-377-14
g. Pull receptacle (J13) down and out of bulkhead.
h. Reconnect harness plug P13 to receptacle J13.
i.
Using screwdriver and wrench, install receptacle J1
NOTE
into the new connector location.
Take care that protective electrical connector cover that was removed at the rear panel is
reinstalled at new location.
j.
Install gasket and cover plates over connector hole patterns at bulkhead and rear panel.
k. Coil loose excess harness so that it will not be damaged.
Follow-on procedures: 1. Install conditioned air intake grille. (See para 4-24.)
2. Install lower front panel. (See para 4-29.)
3. Install rear panel. (See para 4-32.)
4-10. INSTALLATIONS THAT REQUIRE REMOVAL OF FABRIC COVER
Some installations require removal of the condenser side fabric cover. This generally applies only when the air
conditioner is positioned inside with condenser and fresh air openings ducted to the outside.
NOTE
If air conditioner is to be installed with condenser side (rear) exposed, the fabric cover
should be left in place if possible.
a. Using screwdriver, remove fourteen screws, four packing with retainer, and eighteen flat washers.
Figure 4-19.
Fabric Cover Removal
b. Carefully remove the fabric cover. Store the cover in a safe place for future use.
4-22
|
