|
| |
TM5-4120-387-14
Section II MAINTENANCE
5-2. AIR CONDITIONER (FABRIC) COVER
For removal, inspection, lubrication, cleaning,
4-13 and figure 4-6.
PROCEDURES
and installation, see paragraph
a.
Repair.
Minor rips, cuts, tears, or punctures may be repaired by applying a
patch to the inside surface.
b.
Replace.
For damage of greater extent, or missing eyelets or snap
fasteners,
replace the entire cover.
5-3. OUTSIDE COVERS, PANELS, GRILLES, SCREENS,
GUARDS, AND INFORMATION PLATES
a.
For removal, inspection, cleaning, and installation, see the following
paragraphs:
o CBR (Chemical, Biological, Radiological) duct cover.
(See para 4-14.)
l Access (charging valves) cover.
(See para 4-15.)
l Connector cover plates.
(See para 4-16.)
Circuit breaker access plate.
(See para 4-17.)
Evaporator air discharge (outlet) grille assembly.
(See para 4-18.)
Evaporator air intake grille assembly.
(See para 4-19.)
l Condenser air discharge guard.
(See para 4-20.)
Condenser coil guard.
(See para 4-21.)
l Fresh air (inlet) screen.
(See para 4-22.)
l Top panel.
(See para 4-23.)
Lower panel.
(See para 4-24.)
b.
Repair.
Repairs are limited to straightening of minor dents, rewelding of
broken welds,
installation of loose or missing rivets,
replacement of loose or
missing gaskets and insulation,
paint touch up,
and replacement of damaged or
missing name plates.
(1) Repair minor dents using standard sheet metal repair practices.
(2) Repair broken welds using standard weld repair practices.
5-2
|
