 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4120-393-14
5-26. Actuating Cylinder (cont)
6.
Remove actuating cylinder.
INSTALLATION
1.
Position actuating cylinder (2) and insert mounting studs through bracket (11).
2.
Using wrench, secure cylinder (2) to bracket (11) with two washers (10) and nuts (9).
3.
Using screwdriver, secure bracket to unit with four screws (8).
4.
Using wrench, connect and tighten flare nut (1).
NOTE
The linkage arms used on opposite sides of the unit are not the same. Take care
that correct part is ordered and properly installed when replacement is necessary.
5.
Using screwdriver and wrench, secure linkage arms (6) and (7) in place with three screws (3), eight washers (5), and
three nuts (4).
6.
Replace the dehydrator. See para 5-16.
7.
Leak test all newly connected joints and those in the repair area. See para 5-12.
8.
NOTE
FOLLOW ON MAINTENANCE:
1.
Install condenser fan and motor. See para 4-60.
2.
Install lower front panel. See para 4-24.
3.
Connect power.
5-62
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
