|
| |
TM 55-8145-221-14&P
0031 00-1
LIGHT ASSEMBLY (EXTERIOR)
0031 00
THIS WORK PACKAGE COVERS:
Removal, Disassembly, Cleaning, Inspection, Repair, Assembly, and Installation
INITIAL SET-UP:
Maintenance Level
Unit
Tools:
General Mechanics Tool Kit (Section III, Item 1, WP 0048 00)
Material/Parts:
Tags, Wire (Item 19, WP 0078 00)
Equipment Condition:
Adhesive Sealant (Item 3, WP 0078 00)
Refrigeration Unit shut down (WP 0006 00).
Wiping Rag (Item 18, WP 0078 00)
Generator Set shut down (WP 0006 00)
Lock Washer (Item 27, WP 0081 00)
REMOVAL.
1.
Disconnect power cable (1, Figure 1) from generator set (2).
2.
Remove nut (3), lock washers (4), screw (5), and clamp (6) from bracket (7).
3.
Remove two screws (8), cover (9) and gasket (10) from box (11).
4.
Tag wiring (12) with wire tags (Item 20, WP 0078 00) and remove three wire nuts (13).
5.
Loosen bushing (14) and pull power cable (1) out of box (11) and through bushing.
DISASSEMBLY.
CAUTION
To prevent damage to the equipment, do not attempt to remove adapter from container
wall unless defective. Adapter is glued in place.
1.
Remove two screws (15) from box (11).
2.
Unscrew box (11) from adapter (16) on container wall (17).
3.
Remove bushing (14) from box (11).
CLEANING.
1. Clean components with wiping rag (Item 18, WP 0078 00). Remove all grease, dirt, and contaminants.
INSPECTION.
1.
Inspect cable (1) for cuts, tears and deterioration of insulation.
2.
Inspect plug on cable (1) for bent, burnt, or broken spades.
3.
Inspect bushing (14) and adapter (16) for cracks.
REPAIR.
1.
Replace defective components.
|
