|
| |
TM 55-8145-221-14&P
0035 00-6
REAR DOOR, LEFT – Continued
0035 00
ASSEMBLY.
1.
Apply sealant tape (1, Figure 2) (Item 16, WP 0078 00) along edge of door panel (2) (inside surface).
__________
WARNING
Door is heavy/difficult to handle. Use two personnel when positioning door.
2.
Using a sling (Section III, Item 9, WP 0048 00) and hoist (Section III, Item 14, WP 0048 00), align door panel (2) with
hinges (3).
3.
Using a torx bit (Section III, Item 6, WP 0048 00) and socket (Section III, Item 6, WP 0048 00, install four hinges (3),
twenty camtainer bolts (4) and camtainer nuts (5) (Item 14, WP 0081 00) on door panel (2).
NOTE
Both brace levers attach the same way
4.
Install brace levers as follows:
a.
Apply a bead of sealant (Item 3, WP 0078 00) around holes in door panel (2) prior to installing hardware (inside
surface).
b.
Position brace lever (6) on door panel (2).
c.
Using torx bit and socket, install eight camtainer bolts (7) (Item 5, WP 0081 00), camtainer nuts (8) (Item 9, WP
0081 00) and chain (9) to secure top and bottom plates (10) to door panel (2).
d.
Position two guides (11) on door panel (2) and using torx bit and socket, install four camtainer bolts (12) (Item 6,
WP 0081 00) and camtainer nuts (13) (Item 9, WP 0081 00).
e.
Position latch (14) on door panel (2), and using torx bit and socket, install four camtainer bolts (12) (Item 3, WP
0081 00) and camtainer nuts (13) (Item 9, WP 0081 00).
f.
Install bolt (15), two flat washers (16) and self-locking nut (17) in the top mounting hole in latch (14).
g.
Follow above steps a. through f. to install remaining brace lever (6).
|
