|
| |
TM 55-8145-221-14&P
0043 00-8
SIDE PANEL REPLACEMENT - Continued
0043 00
INSTALLATION – Continued.
NOTE
Sealant (Item 3, WP 0078 00) is to be applied to each angle plate before installation.
9.
Apply sealant (Item 3, WP 0078 00) around inside surface of screw and rivet holes on four angle plates (7, 8, 9 and 10,
Figure 2).
NOTE
Angle plates are positioned as marked during removal.
10. Position angle plates (7 and 8) against side panel (1), floor panel (6) and install 32 screws (11) in bottom holes of angle
plates.
11. Attach two drain plug chains (12) with pop rivets (13) (Item 23, WP 0081 00) to bottom flange of angle plates (7 and 8).
12. Using angle plate (8) as a template, drill .197 diameter hole in side panel (1) and install pop rivet (13) (Item 23, WP 0081
00).
13. Using angle plates (7 and 8) as a template, drill .125 diameter holes in side panel (1) and install 30 screws (11).
|
