|
| |
TM 55-8145-221-14&P
Change 1
0006 00-2
OPERATION UNDER USUAL CONDITIONS – Continued
0006 00
PREPARATION FOR USE AND ASSEMBLY – Continued.
TEMPERATURE RECORDER (Figure 2).
1.
Unfasten latch (1) and open cover (2).
2.
Lift stylus (3) until it stays out from paper chart (4).
3.
Remove knurled knob (5).
4.
If installed, remove old paper chart.
CAUTION
To prevent damage to temperature recorder, do not over wind timer movement.
5.
Insert winding key (6) into winder hole (7) and wind timer movement clockwise until key stops. Be careful not to
over wind. Replace key into storage clip (8).
NOTE
Spare charts are stored in the document holder.
6.
Retrieve one new chart from the document holder. Position new chart (4), making sure chart fits under four retention
tabs (9) on platen (10).
7.
Rotate chart (4) so that correct day (1 to 31) and morning (M) or night (N) is aligned with STARTING TIME mark
(11).
8.
Install knurled knob (5).
9.
Slowly lower stylus (3) so that stylus rests on chart (4).
10
Close cover (2) and fasten latch (1).
|
