|
| |
TM 9-4110-257-14
(2) Using multimeter set to measure continuity, check engine temperature switch (2) continuity between
connector and base. Continuity should not be indicated. If continuity was indicated, replace engine
temperature switch.
(3) If no failure was indicated, connect wire lead (1) using tag and wiring diagram (fig. 1-4). Remove tag.
b. Removal.
(1) Tag and disconnect wire lead (1).
(2) Remove engine temperature switch (2) and washer (3). Discard washer.
c. Installation.
(1) Install new washer (3) and engine temperature switch (2).
(2) Connect wire lead (1) using tag and wiring diagram (fig. 1-4). Remove tag.
NOTE
FOLLOW-ON MAINTENANCE:
Close right side condenser door.
Connect battery (para 4-35) and put unit back into service.
4-129
|
