|
| |
TM 9-4110-257-14
(3) Fuel pump to fuel filter hose assembly.
(a)
Slide clamp (21) over hose (23) end and install hose onto eye (26). Tighten clamp.
(b)
If eye (26) was removed, install new washer (27), eye, new washer (25), and union (24).
(c)
Slide clamp (22) over hose (23) end and install hose onto eye (31). Tighten clamp.
(d)
If eye (31) was removed, install new washer (32), eye, new washer (30), and union (29).
(e)
Install loom (20) over hose (23) and secure using tie down straps (19) as necessary.
(4) Fuel filter to injection pump hose assembly.
(a)
Install new washer (37), eye (36), new washer (35), and union (34).
(b)
Install loom (57) and secure using tie down straps (56) as necessary.
NOTE
The following procedures apply to both cylinders.
(c)
Install new washer (55), eye (54), washer (53), union (52), new washer (51), fuel pipe (50), new washer
(49), and union (48).
(d)
Install new washer (47), eye (46), new washer (45), and union (44).
(e)
Install new gasket (43), cover (42) and three screws (41).
(f)
Install cylinder casing (40), two flat washers (39), and screws (38).
(5) Injection pump to nozzle tube assembly.
CAUTION
Always use two wrenches when tightening the fuel pipe to prevent
turning the nozzle or injection pump fitting.
(a)
Install fuel pipe (59) and tighten two flare nuts (58).
(b)
Install new gasket (43), cover (42) and three screws (41).
(c)
Install cylinder casing (40), two flat washers (39), and screws (38).
NOTE
FOLLOW-ON MAINTENANCE:
Close left side condenser door.
Connect battery (para 4-35) and put unit back into service.
4-145
|
