|
| |
TM 9-4110-257-14
4-62. IN-LINE FUEL FILTER REPLACEMENT.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Materials/Parts:
Equipment Conditions:
Wiping Rags
Refrigeration unit shut down (para 2-7) and battery
3, Appendix E
disconnected (para 4-35).
Left side condenser door open.
WARNING
Hoses may contain fuel. Injury to personnel can occur when removing.
Appropriate actions should be taken to contain spills.
NOTE
Note fuel flow direction before removal.
a.
Removal. Loosen two clamps (1) and remove in-,line fuel filter (2) from hoses (3).
b.
Installation.
(1) If clamps (1) were removed, slip clamps over hose ends (3).
NOTE
Be sure to observe flow direction noted during removal.
(2) Install in-line fuel filter (2). Tighten clamps (1).
4-152
|
