|
| |
TM 9-4120-367-14
TM 07592B-14/1
CHAPTER 5
UNIT MAINTENANCE
5.1 GENERAL MAINTENANCE PROCEDURES.
This task covers removal, testing, inspection, splicing wires,
crimping terminals, insulating joints and soldering connections.
Applicable Configurations:
All
Test Equipment:
Multimeter
Special Tools:
None
Materials/Parts:
Heat-shrink Tubing
Solder
Solvent P-D-680
Detergent
Cleaning Cloths
Equipment Descriptions:
Power OFF; installed in shelter
Special Environmental Conditions:
None
General Safety Instructions:
See WARNING page
References:
None
Troubleshooting References:
None
Personnel Required:
Unit Maintenance
Location/Item
Removal
Action
The electrical circuits in the air conditioner are
completed by individual wire leads or by wire leads
laced or enclosed in wire ties to form a wiring har-
ness.
All of the wiring carries code numbers.
When repairing or replacing the wiring harness or
individual wires, refer to the wiring diagrams fig-
ures FO-1, FO-3, FO-5, FO-7, or FO-9.
Disconnect air conditioner power sup-
ply before peforming maintenance
work on electrical system.
Remarks
High voltage can kill.
5-1
INITIAL SETUP
a.
b .
c.
|
