|
| |
TM 9-4120-367-14
TM 07592B-14/1
Location/Item
Cleaning
Inspection
Action
a.
b.
c.
d.
e.
f.
g.
h.
a.
b.
a.
b.
c.
a.
b.
c.
d.
e.
Remove condenser top cover.
Loosen screw on mechanical post and disconnect
push-pull control.
Remove two screws and Iockwashers and lift vent
damper from air conditioner.
Remove both evaporator louvers.
Remove screw, washer, nut, spacer and loop
clamp.
Loosen screw and mechanical post to free end of
control wire core.
Remove outer nuts from both ends of control outer
casing and remove push-pull control.
Remove screw, nut, two spring washers and ac-
tuator.
Wipe off all loose dirt with dry cloth.
Wipe off any buildup of “caked” on dirt.
Inspect push-pull control for smooth operation of
core in casing.
Inspect vent damper for bent or broken condition.
Inspect for loose or damaged rubber seal or damp-
er. Cement loose rubber or replace as required.
Vent Control Actuator. Install actuator, screw, two
spring washers and nut.
Vent Damper. Install vent damper in opening in
housing.
Secure vent damper cover to housing with two
screws and Iockwashers.
Push-Pull Control. With one nut on each end of
outer casing of push-pull control, install ends of
control through opening in housing.
Install outer nuts and insert ends of wire core into
mechanical posts of damper and actuator.
Remarks
5.22 FRESH AIR DAMPER. - Continued
Removal
Installation
5-71
|
