|
| |
TM 9-4120-367-14
TM 07592B-14/1
5-27 CONDENSER FAN SWITCH S7. This task covers removal, testing and installation.
INITIAL SETUP
Applicable Configurations:
All
Test Equipment:
None
Special Tools:
None
Materials/Parts:
Heat-shrink Tubing
Solder
Ty Rap
Hot Air Dryer
Equipment Description:
Power OFF; installed in shelter
Special Environmental Conditions:
None
General Safety Instructions:
See WARNING page
References:
None
Troubleshooting References:
None
Personnel Required:
Refrigeration Specialist
Location/Item
Removal
Testing
Action
a.
b.
c
d.
e.
f.
g.
Disconnect power supply.
Remove condenser section top cover.
Cut "ty-rap" from plug P7 wires.
Disconnect plug P7.
Remove two screws and washers.
Pull switch away from frame.
Unsolder or cut wires at switch.
See table 4-3.
Remarks
High voltage can kill.
5-81
|
