|
| |
TM 9-4120-367-14
TM 07592B-14/1
Table 3-1. AC Power Supply Requirements
Model
Voltage
Phase
Hertz
F18H
230
Single
50/60
F18H-3
208
3
50/60
F18H-4
208
3
MHP-20-4-08
208
3
J11
Table 3-2. J1 and J11 Wiring
Connector J1
Schematic *
F18H
Figure 3-3
Figure 3-4
FO-1
F18H-3
Figure 3-5
Figure 3-6
FO-2
F18H-4
Figure 3-5
Figure 3-6
FO-3
MHP-20-4-08
Figure 3-7
Figure 3-8
FO-9
* Foldout located at back of manual.
NOTE
Two input power connectors are provided on the air conditioner. Connector J1 is
located on the evaporator section above the control module. Connector J11 is lo-
cated on the condenser section right above the sight glass. Wiring at the terminal
boards TB3 must be connected to the connector which is to used for input power.
NOTE
It may be necessary to isolate neutral from ground in the air conditioner to prevent
electrical interference. It will be necessary to remove the air conditioner from the
installed position to remove the jumper. If possible, determine the possibilities of
electrical interference before installing the air conditioner.
3-7
3.5 INSTALLATION OR REMOVAL. - Continued
M o d e l
400
400
|
