|
| |
ARMY TM 94120-381-14
NAVY EE-000-CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
6-6.
REAR EVAPORATOR PANEL - Continued.
2.
RFI Gasket.
a.
Remove damaged gasket (10) from panel (6).
WARNING
Acetone and Methyl-Ethyl Ketone (MEK) are flammable and their vapors can be
explosive. Repeated or prolonged skin contact or inhalation of vapors can be toxic. Use
a well ventilated area, wear gloves, and keep away from sparks or flame.
b.
Clean area for new gasket, using acetone or MEK and a stiff brush.
c.
Coat surfaces of metal and gasket with adhesive. Let both surfaces dry until adhesive is tacky but will not stick
To fingers.
d.
Starting with an end, carefully attach gasket to metal surface. Press into firm contact all over.
3.
Insulation
a.
Remove damaged insulation (4).
b.
Clean area for new insulation, using acetone or MEK and a stiff brush.
c.
Cut insulation (4) to fit.
d.
Coat surfaces of metal and insulation with adhesive. Let both surfaces dry until adhesive is tacky but will not
stick to fingers.
e.
Starting with an end, carefully attach insulation to metal surface. Press into firm contact all over.
f.
If insulation retainer (3) and rivet (5) were removed, install new retainer (3) and rivet (5).
INSTALLATION
1.
Install hose (1) and tighten clamp (2).
2.
Place panel (6) into mounting position.
3.
Install 10 screws (7), lockwashers (8), and flat washers (9).
FOLLOW ON PROCEDURE
If air conditioner is to be installed in a van or shelter, refer to the van or shelter technical manual for installation
procedures.
6-4
|
