|
| |
TM 9-4120-389-14
(3)
Repair minor fabric rips, cuts, tears or punctures by applying a patch of duct tape (item 11,
Appendix E) to inside surface.
d.
Installation
(1)
Align eyelets to three casing mounting holes.
(2)
Secure top of fabric cover to rear panel using three screws, lockwashers and flat washers.
(3)
Secure bottom of cover into snap fastener in bottom casing.
(4)
If unit is to be returned to normal operation, unsnap cover, rollup the cover and secure with two (2)
straps.
4-13. METAL COVERS, INFORMATION PLATES, LOUVERS AND GUARDS |
a.
For removal, inspection, servicing and installation, see the following paragraphs:
Top cover (see para. 4-14).
Access (charging valve) cover (see para. 4-15).
Information plates (see para. 4-16).
Evaporator outlet louver (see para. 4-17).
Evaporator inlet louver (see para. 4-18).
Condenser outlet guard (see para. 4-21).
Ventilation guard (see para. 4-22).
b.
Repair. Repairs are limited to straightening of minor dents, rewelding of broken welds, installation of
loose or missing rivets, replacement of loose or missing gaskets and insulation, paint touch up, and
replacement of damaged or missing name plates.
(1)
Repair minor dents using standard sheet metal repair practices.
(2)
Repair broken welds using standard weld repair practices.
(3)
To replace loose or missing rivets:
(a)
Drill old rivet using a drill bit slightly smaller than the diameter of old rivet body.
(b) Install replacement rivet.
4-63
|
