|
| |
TM 9-4120-389-14
b.
Removal
(1)
Remove screw, lockwashers, flat washer and locknut that secure the wiring
harness clamp to the condenser motor support.
(2)
Move wiring harness and clamp out of the way.
(3)
Remove screw and lockwasher that secure the brace to the scroll.
(4)
Remove two screws, lockwashers, flat washers and nuts that secure the brace to the condenser
motor support.
(5)
Remove the brace.
(6)
Remove three bolts and lockwashers that secure the top angle of the condenser motor support to
the casing.
(7)
Remove three bolts, flat washers and locknuts that secure the condenser motor support to the
casing bottom angle.
(8)
Remove the condenser motor support.
c.
Installation
(1)
Align two through holes of the top angle of condenser motor support with
mounting hardware of casing.
(2)
Loosely install three bolts and lockwashers that secure the top angle of the condenser motor
support to the casing.
(3)
Loosely install three bolts, flat washers and locknuts that secure the condenser motor support to the
casing bottom angle.
(4)
Tighten hardware installed in steps (2) and (3) above.
(5)
Loosely install brace to the scroll with screw and lockwasher.
(6)
Loosely install brace to condenser motor support with two screws, lockwashers, flat washers and
nuts.
(7)
With clamp install on wiring harness, align through hole of clamp with through hole on condenser
motor support.
(8)
Secure clamp to condenser motor support with screw and lockwasher, flat washer and locknut.
(9)
Secure hardware installed in steps (5) and (6).
Follow-on procedure: Install condenser fan motor (See para. 4-25).
4-93
|
