Installation Instructions

TM 9-4120-428-14

0016 00

Connectors are provided to permit remote installation of the control module. To install the control module in a remote

location, within the conditioned space, the following steps must be taken.

SENSING BULB CLAMPS

SENSING BULB

RETURN AIR LOUVER

CONTROL MODULE MOUNTING SCREW

CONTROL MODULE

EXTERNAL GROUND CONNECTION POINT

1. Remove the return air louver (WP 0021 00).

2. Loosen the sensing bulb clamp screws and slip the sensing bulb out of clamp.

3. Loosen the control module mounting screw and carefully pull control module out of unit. Use care to avoid damage

to sensing line.

4. Carefully work the sensing bulb through the frame and out of the unit.

NOTE

The sensing bulb controls thermostatic action of the TEMPERATURE SELECTOR. In

should be mounted where a true room or enclosure temperature will be indicated. Do not

place near heat of cool producing items. False temperature control will result.

5. Determine where the control module will be located.

6. Secure the control module and the sensing bulb.

7. The receptacle and plug needed to fabricate the interconnecting cables are provided with the unit. Determine the

length of wire needed to connect the plug and the receptacle between the unit and control module.

8. Fabricate the interconnecting cable for the F9000H-4SPFI and connect cable between P2A/B and J2A/B per the

Remote Control Cable Diagram.

9. Install the air louver.

No other preparation is necessary if the air conditioner is installed by the typical exterior wall opening method and operated

as a self-contained unit.

0016 00-4