|
|
DRAFT
TB 9-2320-279-13-1
AC TEMPERATURE CONTROL SWITCH REPLACEMENT - Continued
INSTALLATION
WARNING
Dry cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and
DO NOT breathe vapors. Keep away from heat or flame. Never smoke when using
dry cleaning solvent; the flashpoint for Type II is 140F (60C), and for Type III it is
200F (93C). Failure to follow this warning may result in death or injury to
personnel.
If personnel become dizzy while using dry cleaning solvent, immediately get fresh
air and medical help. If solvent contacts skin or clothes, flush with cold water. If
solvent contacts eyes, immediately flush them with water and get immediate
medical attention.
HEMAC043
NOTE
Perform Steps 1 through 3 if temperature label was removed.
1. Clean center cover (5) where temperature label (14) was mounted with dry cleaning solvent.
2. Peel paper back off of temperature label (14).
3. Install temperature label (14) on center cover (5).
NOTE
Install temperature control switch as noted prior to removal.
4. Install temperature control switch (9) on center cover (5) with nut (13).
5. Install knob (12) on temperature control switch (9) and tighten two screws (11).
0044-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |