|
|
TB 9-2320-279-13-1
1. COMPRESSOR INSTALLATION.
This task covers:
a. Compressor Installation.
References
INITIAL SETUP
None
Models
Equipment Condition
All
Shut off engine (TM 9-2320-279-10)
Test Equipment
Alternator and pulley removed
(TM 9-2320-279-20)
None
Left splash guard removed
Special Tools
(TM 9-2320-279-20)
Engine cover opened (TM 9-2320-279-10)
Belt Tension Gage
Skid plate grill removed (TM 9-2320-279-20)
Supplies
Heater compartment covers removed
(TM 9-2320-279-20)
Alternator Pad
Heater assembly removed (TM 9-2320-279-20)
Bracket Assembly
Heater control panel optic ribbon removed
(4) Screw-7/16-14 x 1 3/4 in.
(TM 9-2320-279-20)
(4) Lockwasher-7/16 in.
Loctite 242
Special Environmental Conditions
Alternator, 130 AMP
None
Alternator Pulley
Screw-1/2-13 in. x 6 1/2 in.
General Safety Instructions
(2) Flange nut-1/2-13 in.
None
Alternator strap
Flange screw-1/2-13 x 3 1/4 in.
Screw-1/2-13 x 2 in.
Washer-1/2 in.
Lockwasher-1/2 in.
Flange nut-1/2 in.
Alternator drive belt set
Compressor and clutch
Washer-3/8 in.
(6) Screw-3/8-16 x 1 1/2 in.
(6) Flange nut-3/8 in.
(2) Compressor strap
Compressor drive belt set
Bracket
Washer-1/2 in.
Lockwasher-1/2 in.
Cushion Clip
Screw-1/2-13 x 1 in.
Screw-1/4-20 x 3/4 in.
Locknut-1/4 in.
Cable tie
Personnel Required
MOS 52C, Utilities equipment repairer (2)
0052-9
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |