 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-364-13&P-1
1. COMPRESSOR INSTALLATION.
This task covers:
a. Compressor Installation.
INITIAL SETUP
Supplies (Continued)
Models
Fuel Line Support Bracket (Return)
All
(4) Screw - 5/16-18 x 1 in.
Test Equipment
(4) Locknut - 5/16 in.
90 Fitting
None
Fitting
Special Tools
Hose Assembly 8 in.
Engine Accessory Drive Assembly
Belt Tension Gage
Bracket
Supplies
(2) Screw - 1/4-20 x 1 in.
(2) Washer - 1/4 in.
Grease (TM 9-2320-364-20, Item 22, Appendix B)
(2) Lockwasher - 1/4 in.
Compressor Mounting Bracket
Screw - 3/8-16 x 1 1/2 in.
Loctite 242
(3) Locknut - 3/8 in.
Compressor and Clutch
Air Conditioner Installation Label
(2) Washer - 3/8 in.
(6) Screw - 3/8-16 x 1 1/2 in.
Personnel Required
(6) Flange Nut - 3/8 in.
Two
(2) Compressor Strap
Compressor Drive Belt Set
References
(2) Nutserts
None
(2) Screw - 3/8-16 x 1 in.
(2) Lockwasher - 3/8 in.
Equipment Condition
(2) Nut - 3/8 in.
Rear noise panel removed, (TM 9-2320-364-20)
(2) Screw - 7/16-14 x 1 3/4 in.
Left side noise panel removed,
(2) Washer - 7/16 in.
(TM 9-2320-364-20)
Screw - 3/8-24 x 4 1/2 in.
Ether start aid assembly removed,
Nut - 3/8 in.
(TM 9-2320-364-20)
Screw - 3/8-16 x 1 1/4 in.
Right side noise panel removed,
Nut - 3/8 in.
(TM 9-2320-364-20)
Connector
Electronic control box (ECB) right side panel
Terminal
removed, (TM 9-2320-364-20)
Seal
Fresh air box removed, (TM 9-2320-364-20)
Secondary lock
Fuel Line Support Bracket (Supply)
Special Environmental Conditions
None
General Safety Instructions
None
0055-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals