 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-4110-262-13&P
0005 00
Thermostat
The setpoint range for the thermostat is 26 to 86 F (-32 to 30 C) or 8 to 86 F (-22 to 30 C). The
thermostat setpoint appears on the digital display when the setpoint key is pressed. Turning the
thermostat dial changes the setpoint. The thermostat controls the operation of the unit by controlling the
power relay, and the heat relay.
Thermometer
The range for the thermometer is 40 to 99 F (-40 to 38 C). Normally the thermometer reading appears
on the digital display. Pressing the Setpoint key causes the thermostat setpoint to appear on the digital
display for 10 to 15 seconds.
Initiating a Manual Defrost Cycle
During a defrost cycle, the defrost indicator light will appear in the display. Before initiating a manual
defrost cycle, make sure the unit is not already in a defrost cycle. The IC interior temperature must be
below 36 F (2.2 C) for a manual defrost cycle to start.
1. Press the manual defrost key.
2. The defrost cycle will continue until the evaporator coil temperature reaches 48 F (9 C).
Manual
Defrost Indicator
Thermostat
Display
Defrost
Light
Window
Dial
Key
ON
Indicator
Light
Setpoint
ON/OFF
Key
Key
Indicator
Light
ADR-300 Unit Controller Display and Keypad
Terminating a Manual Defrost Cycle
Once initiated, the defrost cycle will continue until the evaporator coil temperature reaches 48 F (9 C). If
necessary, a manually initiated defrost cycle may be terminated by turning the ADR-300 off and then
back on.
0005 00-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals