INSTALL - TM-10-4110-262-13-P0229

TM 10-4110-262-13&P

0043 00

INSTALL

DTS

1. Position the DTS so that the screw holes align with the mounting holes in the evaporator coil.

2. Insert the mounting screws and tighten.

3. Connect the DTS wire from the refrigerator wiring harness at the connector.

4. Restrain loose wires with wire ties.

5. Install the two screws holding the switch on the side of the evaporator coil.

Drain Pan

1. Support the drain pan in position.

NOTE

If necessary, remove shelving panels to install the drain pan.

2. Install the clamp on the hot gas drain pan heater. Do not tighten the bolt.

3. Start threading the four bolts to the bottom of the drain pan. Use the washers with gaskets.

4. Tighten the bolt on the clamp used on the hot gas drain pan heater.

5. Tighten the four bolts that you threaded in Step 9.

6. Position the drain pan and align the bolt holes.

7. Install all the bolts, but do not tighten at this time.

8. Tighten the bolts after installing all the bolts.

9. Use wire tires to secure wires.

0043 00-3