Heating Element - TM-10-4110-262-13-P0232

TM 10-4110-262-13&P

0044 00

CAUTION

The evaporator coil fins are fragile and easily bent or otherwise

deformed. Deformed fins reduce the performance of the refrigeration

system. Place a folded piece of cardboard or other device over the fins to

protect the fins while working near the coil.

CAUTION

Take care to avoid bending, kinking or otherwise damaging the hot gas

heating coil.

2. Remove the four screws from each side of the drain pan and one screw from the middle of the

evaporator opening. Lower the drain pan.

3. Remove the two lower evaporator grille bolts (8 millimeters).

4. Remove the four bolts from the rear of the drain pan.

CAUTION

Drain pan heater is attached to the pan. Not removing the clamp may

damage the refrigerant line. Failure to comply may result in damage to

equipment.

5. Gently lower the pan to access the hot gas drain pan heater clamp on the right side.

6. Remove the 8 millimeter bolt from the clamp.

7. Remove the drain pan.

Heating Element

1. Trace the heater wires to the connector near the defrost termination switch and disconnect.

2. Pull the wires to the front of the evaporator coil.

3. Remove the rubber grommet.

4. Remove the rubber grommet from the wires.

5. Remove the heating elements from the retaining clips on the coil by gently rotating the clips away

from the evaporator coil. Take care to avoid bending or damaging coil fins.

0044 00-2