|
| |
TM 10-4130-239-14
4-38.
HIGH TEMPERATURE THERMAL SWITCH REPLACEMENT (CONT)
2.
“
Locate two termials on back of high temperature thermal switch.
3.
Place multimeter red lead on one terminal.
Place black lead on
other terminal.
Multimeter should show more than 1 ohm.
4.
If multimeter does not show more than 1 ohm, replace switch.
Unsolder two wires from thermal switch.
Remove thermal switch.
NOTE
Ensure COVER PLATE is on WIRE HARNESS before
soldering.
1.
Install new thermal switch.
Solder two wires to thermal switch
terminals.
2.
Install water pump (para 4-37).
4-87
|
