|
| |
TM 10-4130-239-14
2-10.
OPERATING INSTRUCTIONS ON DECALS AND INSTRUCTION PLATES (CONT)
S M WC
OPERATING PROCEDURE: Refer to O & M Manual regarding sanitizing
and maintenance,
START-UP PREPARATION
Remove auxiliary equipment from duffle bag
Route water hose from supply source and connect to strainer kit assembly
Turn strainer so that arrow on side agrees with flow direction
Connect a second hose between strainer and WARM IN fitting on SMWC
CAUTION: DO NOT OPERATE WITHOUT STRAINER
Route a third water hose to return cooled water to supply source
Connect to COOL RECIRCULATE fitting on SMWC
Connect nozzle hose to COOL DISPENSE fitting on SMWC
Open hinged lid of SMWC Leave open while operating
Check engine oil level, add oil if required. NSN 9150-00-166-6705 (15W40)
Attach fuel hose to FUEL fitting on SMWC and other end to fuel source,
NSN 9130-00-160-1817 (Combat Automotive Type 1)
Install muffler on exhaust manifold
Be sure water valves at tanks, if provided, are open
Hold engine switch in START position
Turn START RUN handle of SMWC to START position
Pull CHOKE for cold start
CAUTION: DO NOT RUN ENGINE UNLESS WATER HOSES ARE CONNECTED
Start engine with pull cord or with 24 or 12 volt DC power source to SLAVE RECEPTACLE.
After approximately 10 seconds or operation, turn START RUN handle to RUN position.
Release engine switch to return to RUN.
Water will automatically recirculate to supply source when COOL DISPENSE nozzle is
not in use.
o
2-30
|
