|
| |
TM 10-6640-227-13&P
C...............................
Operator/Crew
O...............................
Unit Maintenance
F ...............................
Direct Support Maintenance
H...............................
General Support Maintenance
D...............................
Depot Maintenance
e.
Column 5. Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools)
and special tools, TMDE, and support equipment required to perform the designated function.
f.
Column 6. Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which shall
be keyed to the remarks contained in section IV.
B-4. Explanation Of Columns In Tool And Test Equipment Requirements, Section III.
a.
Column 1. Reference Code. The tool and test equipment reference code correlates with a code used in the
MAC, section II, column 5.
b.
Column 2. Maintenance Category. The lowest category of maintenance authorized to use the tool or test
equipment.
c.
Column 3. Nomenclature. Name or identification of the tool or test equipment.
d.
Column 4. National Stock Number. The National stock number of the tool or test equipment.
e.
Column 5. Tool Number. The manufacturer's part number.
B-5. Explanation Of Columns In Remarks, Section IV.
a.
Column 1. Reference Code. The code recorded in Column 6, Section II.
b.
Column 2. Remarks. This column lists information pertinent to the maintenance function being performed as
indicated in the MAC, section II.
Section II. MAINTENANCE ALLOCATION CHART
(1)
(2)
(3)
(4)
(5)
(6)
Maintenance Level
DIRECT
GEN.
Group
Maintenance
UNIT
SUPPORTSUPPORT
DEPOT
Tools and
Number
Component/Assembly
Function
C
O
F
H
D
Equipment
Remarks
01
CWS1 CUBER
INSPECT
0.1
REPLACE
1.0
2
REPAIR
4.0
1,2,3,4
B3
|
