How to Locate Repair Parts. - TM-5-4110-217-24P0010

TM 5-4110-217-24P

Description. Indicates the Federal item

TM 5-4110-217-14

Operator, Organizational,

Direct Support, and General

name and, if required, a minimum description to identify

Support Maintenance

the item. Items that are included in kits and sets are

Manual

listed below the name of the kit or set with the quantity

LO5-4110-217- 12

Lubrication Order

of each item in the kit or set indicated in the quantity

incorporated in unit column. When the part to be used

e. These ellipsis or dots are utilized to

differs between serial numbers of the same model, the

indicate indents that show assembly component parts

effective serial numbers are shown as the last line of the

relationship.

description. In the Special Tools List, the initial basis of

issue (BOI) appears as the last line in the entry for each

How to Locate Repair Parts.

special tool, TMDE, and support equipment. When

density of equipments supported exceeds density

a. When National Stock Number or Part

spread indicated in the basis of issue, the total

Number is Unknown.

authorization is increased accordingly.

(1) First. Using the table of contents, determine

Unit of Measure (U/M). Indicates the

the functional group within which the repair part belongs.

standard of the basic quantity of the listed item as used

This is necessary since illustrations are prepared for

in performing the actual maintenance function. This

functional groups, and listings are divided into the same

measure is expressed by a two-character alpha betical

groups.

abbreviation (e.g., ea, in, pr, etc).When the unit of

(2) Second. Find the illustration covering the

measure differs from the unit of issue, the lowest unit of

issue that will satisfy the required lowest unit of

functional group to which the repair part belongs.

measure that will satisfy the requisitioned

h. Quantity Incorporated in Unit. Indicates

(3) Third.

the quantity of the item used in the breakout shown on

Identify the repair part on the

the illustration figure, which is prepared for a functional

illustration and note the illustration figure and item

group, subfunctional group, or an assembly. A "V"

number of the repair part.

appearing in this column in lieu of a quantity indicates

(4) Fourth. Using the Repair Parts Listing, find

that no specific quantity is applicable (e.g., shims,

spacers, etc.).

the figure and item number noted on the illustration.

When National Stock Number or Part Number

Special Information.

is Known.

(1) First. Using the Index of National Stock

Usable on codes are shown in description

column. Uncoded items are applicable to all models

Numbers and Part Numbers, find the pertinent National

and/or serial number range. Identifications of the usable

stock number or part number. This index is in NIIN

on codes used in this publication are:

sequence followed by a list of part numbers in

Code

USED ON

ascending alphanumeric sequence, cross-referenced to

CMJ

Model RMP-J/1-10G

the illustration figure number and item number. repair

CUH

Model RMP-J/11-100E6. Abbreviations.

parts.

(2) Second. After finding the figure and item

b. Parts which r -quire manufacture or

number, locate the figure and item number in the

Abbreviations.

assembly at a level higher than that authorized for

installation will indicate in the source column the higher

Abbreviations

Explanation

level.

ADJ

ADJUSTING

c. Repair parts kits and gasket sets appear as

ALUM

ALUMINUM

the last entries in the repair parts listing for the figure in

DIA

DIAMETER

which its parts are listed as repair parts or are listed at

DRIVE

the end of the repair parts listing for the last Figure

EXT

EXTERNAL

containing parts of the kit.

FIG

FIGURE

d. The following publications pertain to the

FRN

FRONT

Refrigeration Unit and its components:

GRADE

HEAD

HEX

HEXAGON

HEIGHT

SIDE DIAMETER

Change 1 4